A house’s plumbing, now serving a business and the homes above it
A downtown building from the 1800s or early 1900s, with a business on the street floor and flats above, often keeps the plumbing of a single house. It has one service pipe from the street, one main valve and one cast-iron stack running down through every floor. Branches were added for each new kitchen or washroom over the years. Water Street and Duckworth Street, the main streets of downtown, run parallel to the harbour, and a building like this may stand on either.
That layout works until something goes wrong, and then everyone in the building feels it. Closing the main for a leak in one flat stops the café’s sinks downstairs. A blockage low in the stack backs up into the lowest opening, usually the business’s floor drain or washroom. The flats above keep draining down onto it. A dripping pipe upstairs shows up on the shop’s ceiling, sometimes well away from where it starts, because water runs along joists before it falls.
Supply pipe of that age adds a slow problem of its own. Old galvanized steel narrows from the inside as it rusts, and a single service pipe sized for one household may now feed several. The plumbing check page for St. John’s describes how an older building’s pipes are read, from the street to the stack.
One main, several tenancies
The main valve of a shared building is usually in the basement, and in a building like this the basement may go with the street-floor tenancy. That makes it worth settling three things before anything leaks. Who can get to the valve at any hour, does it still turn, and does each unit have a valve of its own?
Where a flat or the shop has no shut-off of its own, an isolation valve on its branch lets one unit be closed while the others carry on. It spares the whole building a shutdown for every repair. Adding valves or rerouting a branch counts as new plumbing, and the City of St. John’s can say if that needs a permit. Leak repair in St. John’s covers finding a leak inside the walls of an older building.
The stack everyone drains through
A shared stack carries everything at once: the café’s sinks, the flats’ toilets and tubs, the shop’s washroom. Grease from a food business, wipes from a flat and scale in an old cast-iron pipe all meet in it, and a slowdown in one place affects every floor. Keeping grease out of the business’s sinks, and wipes out of everyone’s toilets, protects the whole building. Drain cleaning in St. John’s explains how a blocked stack or building drain is cleared.
When a stack needs repair, the work has to be planned around both the business hours and the people living above (the second and fourth answers below).
Arranging plumbing work in a shared St. John’s building
Three of HomeBrill’s ten plumbing jobs fit a shared building: leak detection and repair, pipe repair and replacement, and drain cleaning. All three are on the plumbing page for the city and area. Call or text (709) 910-9100 and tell HomeBrill what the building holds, where the main is, who else will be affected and what you have seen. Then ask whether it can take the job on. Plumbing begins at $80 with HomeBrill; ask on that call what your own job would cost. Plumbing hours begin at 8:00 am, Monday to Saturday, and run to 7:00 pm, so ask whether a visit can be booked before the business opens.